Diamondback Fitness 660Tm - Manual (Page 7)

7
6 0 0 S E R I E S T R E A D M I L L O W N E R’ S M A N U A L
660T Assembly Instructions
WARNING:
FOLD THE TREADMILL UP BEFORE
REMOVING FROM THE BOX.
Upright Posts Assembly
1. Connect the wire harness connectors before assembling Left up-
right post into the upright post receptor of the base frame.
2. Slide the Left upright post into the receptor. Locate the L shaped
upright brace. Insert 4 bolts with washers into the post, making
sure the rear 2 bolts go through the upright brace. Insert 1 bolt
with washer through the remaining hole in the upright brace. Do
not fully tighten these bolts yet. Be careful not to pinch the wire
harness when installing. (See figure A.)
3. Assemble the Right upright post with the same procedure as
Left upright post. Do not tighten these bolts until the console
assembly has been installed.
Figure A
The Horizontal Handlebar
1. Insert the Horizontal handlebar into Left and Right upright posts.
(See Figure B.)
2. Secure handlebar with long bolt and washer on the left side and
short bolt and washer on the right side. Be sure not to pinch the
wire harness inside the left upright post.
3. Slightly tighten these two bolts with an Allen wrench. Do not
tighten these bolts until the console assembly has been installed.
Figure B
Console Assembly
1. Connect the wire harness from the console with the wire harness
from Left upright post before sliding the console assembly into
the upright posts. Any excess wiring must be carefully inserted
(store) back into the handlebar before installing the console onto
the upright posts. Be careful not to pinch the harness when
assembling.
2. Fasten the console assembly by inserting 2 bolts and washers
on the back of the console on each side. Tighten these bolts
with an Allen wrench. (See Figure C.)
3. Now tighten the 5 bolts on each side of upright posts and
upright brace and one bolt on each side of horizontal handlebar.
4. Make sure all hardware on the treadmill is securely tightened.
Figure C