Digital Alert Systems R198 User Manual
Page 12
Changing the Network settings – Enter the new network settings as desired. When you
have reviewed your settings and want to keep them ,click on “Submit”. These new changes
will show up in the Network tab, but will not take affect until the power is removed and reap-
plied to the unit.
Permanent storage of IP change – To store the new Network settings into memory,
remove the power from the unit, wait approximately 10 seconds, and reconnect the
power to the unit.
Note: To set the unit back to the default Network settings, remove the power from the
unit. Using a small probe, press and hold the Reset button on the back panel on the unit
while reconnecting the power to the unit. Keep the button depressed for 10 seconds
after re-applying power, then release the Reset button .The unit will be reset to the
default IP address of 192.168.1.2.
12