IHSE USA 434 Series SD- VUE/5x - Manual (Page 18)

16 SD-VUE USB Mini Extender Range
Local Unit Installation
To install a Local Unit:
1. It is recommended that the PC and other devices are switched off before
connection.
2. Using the supplied CPU video/USB cable, connect the Local Unit to the
CPU as shown in Figure 4.
We recommend that the Local Unit is connected directly to a CPU USB
port (Root Hub). If the Local Unit has to be connected through an external
hub, you should ensure the hub is self-powered (not bus powered), or
connect a 5V PSU (500mA) to the Local Unit.
3. If you want local access to the CPU, connect the video output(s) on the
Local Unit to suitable monitors. Connect a USB mouse and a USB
keyboard directly to other USB ports on the CPU or a connected hub.
4. If you have an audio and serial enabled system, connect the audio cables
between the computer and Local Unit as follows:
Computer Local Unit
Audio Out (green) Audio In
Audio In/Microphone (pink/blue) Audio Out
5. If appropriate, connect the supplied serial cable between the serial port on
the computer and the Local Unit.
6. For single video units, connect the CATx cable to the INTERCONNECT
socket on the front of the Local Unit. For dual-head systems, connect the
CATx cables from the Remote Unit to the corresponding
INTERCONNECT ports (1&2) on the Local Unit (see Figure 5).
7. Power up the PC.
The Local Unit normally takes power through the USB connection. In
video only applications, or when the USB interface has limited power
(from a bus-powered hub, for example), an external 5V PSU may be
required. The power LED will indicate if an external PSU is required (see
page 17).
Please contact Technical Support to obtain a suitable power supply.