Sequence – ILS ILS14A User Manual
Page 15
13
In order to input IR Learning into the Controller, the PC RS-233 port whould be connected with the Controller’s control RS-232 port.
Sequence
1.
First copy vb6ko.dll file in the System32 folder, and install Vbruntimes.
(If it is not installed, you will get an error.)
2.
Next, execute Protocol Input and set the COM Port. (check your PC’s port number.)
3.
Press the Open button, Program Input LED is lit.
4.
On the Window screen, press the ON/OFF button.
5.
Press the Remote control’s ON/OFF button while you point it at the Controller’s IR Receiver.
6.
If the input was successful, the LED blinks 3 times. If it wasn’t, the LED blinks rapidly.
7.
Input other buttons following the above procedure.
8.
When all input is completed, use the IR Cable to connect to the Controller’s IR Port, and place it near to the
IR Receiver you want to control.