Infloor PAP Press Tool 24535 and 24538 - Manual (Page 4)

4
2, Available jaws
The pressing jaws used on the pressing tool 24535 are smaller than the jaws on pressing tool 24538,
corresponding jaws for them and read the notes carefully.
Table of available pressing jaws
All the jaws below are U-profile for pressing Infloor Sales & Service F5 fitting.
Notes:

Specification number is engraved on one side of each jaw. The number stands for the pipe
outer diameter by mm. Please make sure the lettered sides of the two opposite jaws are
positioned on the same side.
 The jaws engraved with specification number alone, stand for U-profile jaws (for pressing
F5 fittings).
3, Preparation before use
Step 1, Choose correct pressing jaws
Appropriate pressing jaw should be selected per the pipe size.
Picture Jaw specifications Suitable tool
23456
24535
1/2" Press Tool Module
24537
5/8" Press Tool Module
24540
24538
1/2” L Press Tool Module
24541
5/8” L Press Tool Module
24542
3/4” L Press Tool Module
24543
1” L Press Tool Module
therefore could not be interchangeably mounted on 24538, please refer to the following table for the