Q-See QSTD5304 - Manual (Page 11)

QSTD5304 Digital Video Recorder User Manual
11
CHAPTER 3 Basic Operation Guide
3.1 How to Start DVR
Notice: Before powering on the unit, please make sure the power input matches the local
power voltage.
To start the DVR:
STEP1 Connect the DVR to AC adaptor and plug in.
STEP2 Turn on the DVR.
STEP3 Wait for the DVR to initialize.
After DVR is powered on, ‘STARTING……’ appears on the screen, which
indicates the DVR is initializing.
After ‘WELCOME’ is displayed, you enter into live display mode. You can
press the "
Menu" button to enter Main Menu.
The symbols displayed on the screen are explained in the following table:
Symbol Meaning Symbol Meaning
LIVE Live picture mode REC Manual recording
A Sensor recording M Motion recording
DISK
Percentage of hard
drive used
V-LOSS Video loss
3.2 Main Menu Setting
There is an administrator setup in the DVR. The administrator has control
over all settings. The username is "Admin", and default password is "123456".
Steps of entering the Main Menu are:
Notice: The instructions in the examples, are the steps using the Remote Control. If using
a mouse the operation may be easier, you would follow the instructions in dialogue boxes and
navigate through menu items. If using the front panel buttons you cannot control PTZ
cameras, but the other operations are the same as the remote control.
STEP1 Press the " Menu" button, input username and password in the
Login interface (as Fig. 3.1), and then you will see the Main Menu (as Fig.
3.2).
STEP2 Move the cursor, and the selected items will be highlighted in
yellow
STEP3
Press " Enter" key to enter the sub-menu, and press "Menu" key to
get back to Main Menu
Fig 3.2 Main
Menu
Fig 3.1 Login