Directed Electronics 1500ESP - Manual (Page 16)

13
© 1999 Directed Electronics, Inc.
To disarm the security system,
turn the ignition key on and
press the Valet ® switch the
preset number of times within
15 seconds. If the system does
not disarm, you may have
waited too long; turn the igni-
tion off and repeat the
process.
IMPORTANT! The Valet ® switch can be programmed to respond to 1-5
presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.
LOCATION OF VALET ® SWITCH_____________________________
Use the Silent Mode to temporarily turn off the arm or disarm con-
firmation chirps by briefly pressing before either arming or
disarming the security system. The confirmation chirp(s) will then
be eliminated for that one operation only. To permanently turn off
the arm and disarm confirmation chirps, contact your installation
dealer.
NOTE: The Warn Away ® Response to lighter impacts is bypassed if the sys-
tem is armed using the Silent Mode. This ensures that the siren does not
chirp in an environment where you don't want chirps to be emitted. The
system is still capable of being triggered by heavier impacts; only the
Warn Away
® Response generated by light impacts is bypassed.
Silent Mode
DRW-35