Directed Electronics 1500ESP - Manual (Page 18)

15
© 1999 Directed Electronics, Inc.
You can also activate Valet ® Mode using the remote transmitter:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solid if you are entering Valet ® Mode and
will turn off if you are exiting Valet ® Mode.
This feature allows you to remotely start and run your vehicle for
a programmable period of time. This makes it possible to warm up
the engine, as well as adjust the interior temperature of the vehi-
cle with the climate control system. If interior heating or cooling
is desired, the climate controls must be preset, and the fan blower
must be set to the desired level prior to remote starting the
vehicle.
IMPORTANT! (1) Never remote start your vehicle when the keys are in the
ignition, except when performing Valet
® Take-Over, and (2) Never start
the vehicle if it is not in either PARK or NEUTRAL.
Pressing and at the same time will begin the remote start
sequence. The parking lights will flash to warn that the motor is
about to start. It is important to release the transmitter buttons
as soon as the parking lights flash. If the buttons are pressed
longer than two seconds, the remote start sequence will stop.
Remote Start
Remote Valet