Lynx Studio LT-MADI User Manual
Page 11
Page 8
8.
Set the JP2 jumper for the MADI 56 or 64 channel modes. MADI devices can utilize 56
channel operation or 64 channel operation. The LT-MADI inputs auto-detect the
appropriate mode, but the outputs must be configured to work correctly with MADI
devices receiving streams from the LT-MADI outputs. It is crucial to consult the
documentation for your MADI equipment to determine which mode is appropriate. See
MADI 56/64 Channel Modes
. 64 channel mode is the LT-MADI default state.
9.
Attach the multi-pin connector on the back edge of the LT-MADI to the LSLOT
connector (JP1) on the Aurora mainboard. The LT-MADI LSLOT connector has a
protective sheath to insure that the pins line up correctly with the Aurora LSLOT
receptacle. When the LT-MADI connector pins appear to be lined up correctly with the
Aurora LSLOT connector press gently until the connector snaps into place. In some
cases, the board may need to be gently flexed for the LSLOT connector pins to line up
correctly with JP1 on the Aurora mainboard.
Use caution to insure that the pins line up as shown. Incorrect installation could
damage the unit.