Maytag JDB1060AW - Manual (Page 30)

©2004 Maytag Appliances Company 16022783 Rev. 0 30
Inner Door Panel
Removal of the Inner Door Panel will allow access to the
Microprocessor Board, Door Switches, Detergent / Rinse
Aid Dispenser, and Vent Assembly.
Removal
1. Disconnect power to the machine.
2. Open the Dishwasher door.
3. Remove the 11 Torx™ screws along the sides and
top of the Inner Door Panel.
4. Separate the Inner Door Panel from the Outer Door.
5. Disconnect wires from the Dispenser Wax Motors
before pulling the Inner Door Panel away from the
Dishwasher.
IMPORTANT: When replacing Inner Door Panel, remove
Inner Door reinforcement, Bottom Seal and install on
new panel.
Detergent / Rinse Dispenser Mechanism
and Reservoir
Checking Operation
1. Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Snap the Detergent Door shut.
4. Gently lift the lever of the dispenser mechanism until
a click is herd. The Detergent Door releases. Re-
lease the lever.
5. Lift the lever again. Now the actuator will lift the Rinse
Aid Plunger.
Service and Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.