Dakota Digital LED Tail Lights LAT-NR161 - Manual

MAN#650159c
INSTALLATION INSTRUCTIONS
LAT-NR161
LED Tail Lights for ’60-‘65 Impala/Bel Air/Biscayne, ’67 Impala,
‘75-‘76 Caprice, and ’71-’73 Mustang
MAN#650159c
Kit Includes:
Installation:
1. Remove the original bulb connector from the back side of the housing.
2. Remove the light bulb.
3. Remove the tail light lens.
• On the 60-65 Impala, the screws are directly in the lens.
• On the 67 Impala, the nuts securing the tail light assembly must be removed first from
inside the trunk. Once the assembly is removed, the screws on the back of the housing
can be taken out.
• On the 75-76 Caprice, the nuts securing the tail light assembly must be removed first from
inside the trunk. Once the assembly is removed, the screws on the top and bottom sides of
the housing are removed and the metal trim taken off. Last the screws holding the lens are
removed so the lens can come off.
• On the 71-73 Mustang, the lens is snapped into place with tabs around the outside edge.
Carefully pry the lens off using a flat blade screwdriver.