Dakota Digital LED Tail Lights LAT-NR161 - Manual (Page 3)

MAN#650159c
8. Secure the back plate with the supplied #6 screw and lock washer.
9. Place the original lens gasket into place and replace the tail light lens. Tighten the screws
down carefully.
Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from
LED assembly to appropriate length once mounted, making sure wires are routed cleanly and
securely.
10. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED
assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and
mating LED assembly wire into a connector and crimp following instructions below.
*For the best connection, soldering is recommended. But to simplify installation, the supplied connectors will provide
a fast weather resistant connection.
The correct crimp method for the supplied connectors is:
1.) Insert UNSTRIPPED wires into the connector and ensure they are all they way in by
observing the clear bottom of the connector to see the wires are touching the end.
2.) Use pliers to push the blue cap down flush with the edge of the clear body, completing the
connection. The connection will only be correct if pressed firmly down with pliers.
GREEN wire
from LED
assembly
GREEN wire
from LED
assembly
Turn Signal wire
from vehicle
harness
BROWN wire
from LED
assembly
BROWN wire
from LED
assembly
Tail Light wire
from vehicle
harness
BLACK wire
from LED
assembly
BLACK wire
from LED
assembly
Ground wire from
vehicle harness
with plastic housings
BLACK wire
from LED
assembly
BLACK wire
from LED
assembly
Attach to metal bolt or screw for
Ground connection with metal
housings
OR