Remotec ZXT-310 V1.2 - Manual (Page 14)

14
seconds • Learn a code
successful
5 Repeat step 2 to 5 to learn other keys. ‐
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: On step 4, if no IR signal received for more than 15 seconds,
the Error LED in front will flashes six times then all LED turn off,
Learning on ZXT-310 mode will exit automatically.
L When you encounter problem, check followings:
− Make sure your original remote is switched to power off.
− Press the key on original remote before learning mode
timeout.
− Keep away from incandescent light and direct sunlight during
learning.
− Make sure IR Transmitter of your original remote alight with
learning diode of ZXT‐310, you may also slight adjust closer or
further away the distance of two devices. Some of remotes
the IR transmitter in hidden behind lens and may not installed
center of remote.
− Make sure the power is good on both devices, especially the
original remote. Use fresh batteries.
Reset ZXT‐310 to factory default
Press and hold “PROG” button for 10 seconds on ZXT‐310, LED will
flash until reset process is completed.