Danby DAC7037M - Manual (Page 8)

" "
" "
" "
" "
7
Operating Instructions
SELECTOR SWITCH
The selector switch controls fan speed and/or
cooling speed. To set desired cooling
temperature, simply rotate the SELECTOR
knob to the appropriate setting.
FAN SPEEDS
LOW FAN will circulate air at minimum
speed without cooling.
MED FAN will circulate air at medium
speed without cooling.
COOLING MODES
LOW COOL
provides cooling with
minimum air circulation. Recommended for
night-time use.
HIGHCOOL provides cooling with
maximum air circulation. Recommended for
quick cooling or for extremely hot days. Once
room is cooled, reduce setting to LOW COOL.
OFF shuts-down the unit completely.
NOTE: Always allow 3 minutes before
switching from one mode to another.
THERMOSTA T
The thermostat automatically controls the
(compressor) cooling cycle and maintains the
selected room temperature. To set the
thermostat, rotate the thermostat knob to the
desired cooling setting (1 warmest ~ 7 coldest).
The fan motor will continue to operate after the
compressor (cooling) has cycled off. This is
normal.
•
" " HIGHFAN will circulate air at maximum
speed without cooling.
•
•
•
•
Selector
Switch
Thermostat
CAUTION
When using FAN control, turn selector switch
slowly allowing unit to adjust.
When using THERMOSTAT, be sure to allow three
minutes before changing temperature. Adjusting
too quickly may cause compresspr to overload.
1
2
3
4
5
6
7
ARRÊT
OFF
TEMP.
" " MED COOL provides cooling with
medium air circulation. Recommended for
night-time use.
•