How to empty the water tank, Continuous drainage – Qlima DD108 User Manual
Page 4
HOW TO EMPTY THE WATER TANK
1. Gently pull out the water tank and
lift it by the handle.
2. Open the sliding which on the left
side of the tank cover.
3. Pour water out. Clean the tank with
water if necessary. Do not use any
chemical solvent to clean it.
4. Slide back the opening and press
back the handle in its original place.
5. Replace the water tank into the unit.
CONTINUOUS DRAINAGE
In certain situations it may be more convenient to set the unit up for continuous drainage. A
hose with an inner diameter of approximately 10-10.5mm is required (not supplied). A typical
reinforced section of a garden hose would be suitable.
1. Ensure the unit is off.
2. Cut out the outlet at the back of the unit with a screwdriver.
3. Pull out the water tank and remove the rubber bung from the water
outlet at the back of the water tank.
4. Pull through the hose and connect to the outlet on the tank.
Retain the rubber bung for future use.
5. Push the tank back into the unit ensuring the hose stays
connected to the outlet. Make sure the tank is right position.