Echo WP-1000 - Manual (Page 19)

W
ater
P
umP
O
PeratOr
'
s
m
anual
19
NOTE
The throttle cable remains assembled to the engine cover and the
spark plug lead and grommet remain installed.
IMPORTANT
DO NOT use a metal scraper to remove dirt from the cylinder fins.
3. Use the brush to remove dirt from the cylinder fins.
4. Remove grass and leaves from the grid between the starter and fuel
tank.
5. When installing the cover, be certain the tab of the metal deflector
shield is in the slot of the cover.
eXhausT sysTem
Spark Arrestor Screen
Level 2.
Parts Required: Spark Arrestor Screen, Gasket
1. Remove engine cover. See “Cleaning Cooling System” for step by
step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3. Remove screen cover (A), screen holder (B), gasket (C), and spark
arrestor screen (D) from muffler body.
4. Clean carbon deposits from screen (D) and muffler components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
6. Install spark arrestor screen, gaskets, and cover.
A
B
C
D