Echo WP-1000 - Manual (Page 26)

26
7. A. Allow engine to cool then remove the spark plug
and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug
hole.
B. Plug the recoil starter handle 2-3 times to
distribute the oil inside the engine.
C. Observe the piston location through the spark plug
hole. Pull the starter handle slowly until the piston
reaches the top of its travel and leave it there.
8. Install the spark plug (do not connect ignition
cable).
9. Using garden hose, run clear water through the
pump, hoses and strainer.
10. Remove prime port plug and fill the pump housing
with 50/50 solution of water and antifreeze.
11. Disconnect suction and discharge hoses.
12. Place a suitable cover over pump.
Removing Pump from Storage
1. Remove spark plug. Cover spark plug hole with clean
rag.
2. Pull starter handle several full strokes to remove oil
from cylinder.
3. Check spark plug gap; install plug. Connect spark plug
cable.
4. Check that guards and shields are fastened in place.
5. Fill fuel tank with fresh fuel mix. (See Fuel sec-
tion)
6. Install suction and discharge hoses making sure
the connections are air tight.
7. Be sure to reinstall pump drain plug securely and
prime the pump before starting.
8. Install prime port plug securely.