Ericsson Multi-Format Receiver RX1290 - Manual (Page 151)

Menus
Table C.6 TTV G.703 Menu
Display Title: Input Description
STATUS
PDH Rate
XXXXX XXXXX is the framing mode of the TTV G.703 input module (None, C-Bit,
M13)
RANDOMISATION XXXX
STUFFING PKTS YYYY XXXX (ACTIVE, NOT ACTIVE)
YYYY (PRESENT, NOT PRESENT)
SETUP
REED-SOLOMON DECODER
XXXXX XXXXX is the EDITABLE Reed-Solomon option. (DISABLED, ENABLED)
INTERLEAVER
XXX XXX.X is the EDITABLE Interleaver option (DISABLED, ENABLED)
INPUT SENSITIVITY
XXXX XXXX is the EDITABLE Signal Level option (NORMAL, LOW)
C.5.5 10/100BaseT IP Input Option Menu
When a 10/100BaseT input interface is used, the Input menu allows the user to edit
the set-up parameters
Table C.7 IP Input Menu
Display title: Input Description
STATUS
Last IP Received From
XXXX.XXXX.XXXX.XXXX
XXXX.XXXX.XXXX.XXXX is the IP address the last MPEG-2 packet was
received from.
Encapsulation Mode
YYYY YYYY (UDP ONLY, RTP ONLY, RTP FEC MODE)
XXXX XXXX status (NO DATA, LINK DOWN, OUT OF REGULATION)
SETUP
UDP PORT NUMBER
XXXXX
XXXXX shows the EDITABLE UDP Port Number on which the IP Input
Card is listening for packets.
IP ADDRESS
XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX is the EDITABLE IP address of the IP input
card.
NETWORK MASK
XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX is the EDITABLE subnet mask of the IP input
card.
DEFAULT GATEWAY
XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX is the EDITABLE gateway address of the IP
input card.
MULTICAST IP ADDRESS
XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX is the EDITABLE multicast IP address of the IP
input card.
EN/LZT 790 0003/2 R1A C-9