Samson Expedition XP800 800W Portable PA System - Manual (Page 18)

18
If the handheld transmitter and
receiver have not been previously
paired, press and hold the button on
the RXD1 receiver for >5 seconds,
until it begins to flash.
Press and hold the Power button
on the transmitter >5 seconds.
This will put both components into
pairing modes. Once the receiver
and transmitter communicate and
sync, the LEDs on both units will
light steady and will be ready for
operation.
Raise the MASTER LEVEL control
and speak or sing into the mic at
a normal performance level while
raising the Channel 4 LEVEL
control until the desired level is
reached.
If you hear distortion check the
LIMITER LED. If it is lit red, turn
down the channel 4 LEVEL on the
XP800 until it lights only occasionally
during loud sounds. If you still hear
distortion, unscrew the microphone
body and use the supplied plastic
screwdriver to turn the Gain control
in the HXD1 transmitter slowly
counterclockwise until the distortion
disappears.
Conversely, if you hear a weak, noisy
signal at the desired volume level
(and with the WIRELESS control of
the XP800 turned fully clockwise),
use the supplied plastic screwdriver
to turn the Gain control in the
transmitter slowly clockwise until the
signal reaches an acceptable level.
Stage XPD1 Wireless System (Optional)