Godox AD600B Witstro TTL All-In-One Outdoor Flash - Manual (Page 9)

- 39 - - 40 -
4. Wireless Flash Shooting
H
MODE
MENU
OFF/ON
GR/CH
Wireless Flash Shooting: Radio (2.4G) Transmission
3. Setting the Communication Group
Short press the < GR/CH > Button to choose group ID from A to E.
Positioning and Operation Range (Example of wireless flash shooting)
● Autoflash Shooting with One Slave Unit
● Use the supplied mini stand to position the slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on the conditions such as positioning of slave units, the
surrounding environment and whether conditions.
Transmission distance is about 80m
H
MODE
MENU
OFF/ON
GR/CH
H
MODE
MENU
OFF/ON
GR/CH
1. Wireless Settings
Press < > Wireless Setting Button again until < > is displayed on the panel.
Long press the < GR/CH > 1
Button for 2 seconds so that
channels ID is displayed on
the LCD panel.
Turn the Select Dial to choose a 2
channel ID from 1 to 32.
Press the < SET > button to 3
confirm.
AD600B adopts Godox 2.4G wireless X system, which has good compatibility with other products of our company.
As a slave unit, AD600B is automatically compatible with Canon E-TTL II system and Nikon i-TTL system according
to the master unit. When receiving the master unit’s signal, “C” or “N” will be displayed on the LCD panel.
Nikon cameras (use X1T-N, TT685N, etc.) and Canon cameras (use X1T-C, TT685C, etc.) can use one or more
AD600B flashes simultaneously.
*As a slave unit, AD600B can be controlled by the following master units: AD360II-C, AD360II-N, TT685C, TT685N,
X1T-C, X1T-N, TT600,etc.
2. Setting the Communication Channel
If there are other wireless flash systems nearby, you can change the channel IDs to prevent signal interference. The
channel IDs of the master unit and the slave unit(s) must be set to the same.
Wireless Flash Shooting: Radio (2.4G) Transmission
H
MODE
MENU
OFF/ON
GR/CH
H
MENU
OFF/ON
GR/CH