Marantz MODEL 40n Stereo 140W Integrated Amplifier (Black) - Manual (Page 23)

Connecting a playback device
You can connect turntables, tuners and CD players to this unit.
This unit is compatible with turntables equipped with a moving magnet (MM) phono cartridge. When you connect this unit to a turntable with a low output
moving coil (MC) cartridge, use a commercially available MC head amp or a step-up transformer.
If you set this unit’s input source to “PHONO” and accidentally increase the volume without connecting a turntable, you may hear a humming noise from
the speakers.
NOTE
0
The earth terminal (SIGNAL GND) of this unit is not for
safety grounding purposes. If this terminal is connected
when there is a lot of noise, the noise can be reduced.
Note that depending on the turntable, connecting the
ground line may have the reverse effect of increasing
noise. In this case, it is not necessary to connect the
ground line.
0 The PHONO input terminals are equipped with a short
pinplug. Remove this plug to connect a record player.
Store the removed short pin-plug in a safe place so as not
to lose it.
DIGITAL AUDIO IN DIGITAL AUDIO IN
AUDIO OUT AUDIO OUT PRE OUT PRE OUT POWER AMP IN POWER AMP IN
HDMI ARC HDMI ARC NETWORK NETWORK
OPTICAL OPTICAL COAXIAL COAXIAL
RECORDER RECORDER SUBWOOFER SUBWOOFER
5V/1A 5V/1A
IN IN
REMOTE CONTROL REMOTE CONTROL
OUT OUT
SPEAKERS SPEAKERS
AC IN AC IN
Bluetooth / Wi-Fi Bluetooth / Wi-Fi
ANTENNA ANTENNA
Bluetooth / Wi-Fi Bluetooth / Wi-Fi
ANTENNA ANTENNA
AUDIO IN AUDIO IN
AUDIO IN AUDIO IN
CD CD LINE LINE
PHONO PHONO SIGNAL GND SIGNAL GND
RECORDER RECORDER
GND
AUDIO
OUT
AUDIO
OUT
L R
AUDIO
OUT
L R
L
L
R
R L R
L
L
R
R
Turntable
Tuner CD player
Contents Connections Playback Settings Tips Appendix
23
Front panel Rear panel
Remote control
unit
Index