LD Systems CURV 500 AVS Portable Array System AV Set with Speaker Cables (Black) User Manual
Page 10
10
DEUTSCH
ENGLISH
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
•••
32
GROUND LIFT
This feature can prevent ground loops that can occur when the subwoofers LD CURV 500
®
S and LD CURV 500
®
SE are connected to
different earthing potentials.
33
SYSTEM IN CURV 500
Female 5-pin XLR socket to connect the CURV 500
®
S Subwoofer (SYSTEM OUT Nº 6 -> SYSTEM IN Nº 33). A suitable 5-pin XLR system
cable is included. NOTE: Use only shielded 5-pin XLR cables with parallel signal lines and full pin assignment. Some commercially available
5-pin XLR cables do not necessarily possess the full pin assignment. When using a CURV 500
®
SE as a subwoofer expansion, the MONO /
STEREO (26) switch on the mixer control panel of the LD CURV 500
®
S Subwoofer must be pressed down (MONO). An incoming audio signal
will be mono summed. When using a CURV 500
®
PES Power Expansion Set to create a Stereo Set, the MONO / STEREO (26) switch on the
mixer control panel must not be pressed down (STEREO). If an incoming stereo signal is present on INPUT LINE 3 / 4 of the LD CURV 500
®
S
Subwoofer, it will be output in stereo.
34
SYSTEM OUT CURV 500 SE
Male 5-pin XLR socket to connect an additional CURV 500
®
SE Subwoofer expansion, or the CURV 500
®
PES Power expansion sets.
35
POWER LED
Lights up once the system is properly connected to the power mains and switched on.
36
POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. A suitable power cord is included in the delivery. IMPORTANT INFORMATION: Replace the fuse
only with a fuse corresponding to the operating voltage. Please observe the label on the housing. If the fuse blows repeatedly, please
contact an authorised service centre.
37
POWER ON / OFF
On / Off switch for the power supply of the device.
38
SATELLITE OUT RIGHT
Speakon-compatible output for controlling one to four LD CURV 500
®
satellites. The use of the LD CURV 500
®
PS Power Set as a Stereo Set
(or the combination of LD CURV 500
®
ES and LD CURV 500
®
PES) requires the use of the satellite output LEFT (left) on the LD CURV 500
®
S
Subwoofer for the control of the LD CURV 500
®
satellites on the left. The LD CURV 500
®
satellites on the right are controlled by the satellite
output of the expansion subwoofer LD CURV 500
®
SE (SATELLITE OUT RIGHT).
39
RELEASE BUTTON
Now slide a CURV 500
®
satellite (LD CURV 500
®
SAT) from the rear onto the SmartLink
®
adapter (LD CURV 500
®
SLA) until it stops, while
pressing the spring-loaded release button on the side of the satellite. Ensure that the two guide rails of the satellite (40) properly slide into
the grooves (41) of the SmartLink
®
adapter or of the lower satellites, in order to ensure a tight fit and establish a contact for both
components. Now release the button to lock the connection and to bring the button back to its original position. Proceed in the same manner
as described above to add other satellites.
44
44
43
43
41
41
41
39
42
41
40
40