LD Systems CURV 500 AVS Portable Array System AV Set with Speaker Cables (Black) - Manual (Page 5)

5
DEUTSCH
ENGLISH
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
•••
SETUP
In order to allow for a wide variety of configuration options, the LD Systems CURV 500 ® array system is designed to be modular. Described
below is a representative setup of the LD CURV 500 ® ES Entertainer Set. Examples of setups for other Sets can be found on the following
pages of this user’s manual.
The LD CURV 500 ® ES Entertainer Set consists of 4 components:
A. subwoofer with mixer, built-in DSP (digital signal processor) and class-D power amplifier for the system components.
B. height adjustable spacer bar.
C. SmartLink ® adapter as the base for up to 4 CURV 500 ® array satellites.
D. Four CURV 500 ® array satellites with the patented click mechanism and WaveAhead ® technology.
Once the subwoofer (A) has been placed in the desired location, the spacer bar (B) is screwed into the subwoofer (flange on the top). When
using 1 or 2 CURV 500 ® satellites, plug the SmartLink ® adapter (C) using the rear flange (mark satellite 1 + 2, upright position, fig. E) onto
the top of the spacer bar; when using 3 or 4 CURV 500 ® satellites using the front flange (mark satellite 3 + 4, forward inclined position, fig.
F). Now slide a CURV 500 ® satellite (D) from the rear onto the SmartLink ® adapter (C) until it stops, while pressing the spring-loaded release
button on the side of the satellite. Ensure that the two guide rails of the satellite properly slide into the grooves of the SmartLink ® adapter
in order to ensure a tight fit and establish a contact for both components. Now release the button to lock the connection and to bring the
button back to its original position. Proceed in the same manner as described above to add other satellites. Now connect the speaker output
SATELLITE OUT of the CURV 500 ® subwoofer with the speaker input INPUT SIGNAL (G) of the SmartLink ® adapter using the supplied speaker
cable. When disassembling, please proceed in reverse order. For fixed installations and desktop applications, a terminal block connector (fig.
H, terminal block included) is located on the back of the SmartLink ® adapter. The speaker input INPUT SIGNAL (G) is parallel wired with the
terminal block connector (H).
D
C
B
A
G
C
F
E
H