IK Multimedia iLoud MTM Immersive Bundle High Resolution Compact Studio Monitors (11 Speakers, Black) - Manual (Page 18)

English
17
Front LED
The front LED will show important information about iLoud MTM’s status.
Operating status
Steady white: iLoud MTM is ON. At power-on the front LED will blink white for few seconds then the speaker
turns on and it will be ready to reproduce audio signals.
Blinking red: clipping. The speakers should never be overloaded to ensure consistent and reference audio
reproduction. If you see the front LED to turn RED you should:
- lower the listening volume by turning down the control room / monitoring level on your console or audio
interface.
OR
- Increase the LF extension control from 40 to 50 or 60 Hz to avoid the system being overloaded by bass.
Blinking white: calibration countdown.
Steady blue: calibration sweeps ongoing.
Blinking blue: calibration calculation.
Faults reporting
Steady red: Irrecoverable amplifier fault. No audio will be reproduced. Turn off the unit immediately.
Blinking orange: Thermal warning and the gain will be reduced by 6dB.
Steady orange: Thermal fault. No audio will be reproduced.
Steady yellow: Power amp fault. No audio will be reproduced.
Blinking purple: Internal Power supply issue. Contact support immediately.