5deutsch francais español english italiano polski, Connections, operating and display elements – LD Systems U3047 HHD2 Dual Wireless Microphone System with Two Dynamic Handheld Microphone (470 to 490 MHz) User Manual

Page 5

Advertising
background image

5

DEUTSCH

FRANCAIS

ESPAÑOL

ENGLISH

ITALIANO

POLSKI

9

1

2

3

7

5

6

4

9

8

470 - 490 MHz (LDU3047)
514 - 542 MHz (LDU3051)
584 - 608 MHz (LDU305)
655 - 679 MHz (LDU306)
823 - 832 MHz and 863–865 MHz (LDU308)

Please note:

The use of the wireless microphone system may require a license, depending on the country of use. For detailed information please

contact the relevant authority in your country.

Pilot tone

The pilot tone function protects a wireless microphone system against interference, for example, unwanted signals from other radio transmission

systems. The transmitter adds a second, inaudible signal (the pilot tone) to the actual signal which is to be transmitted. The receiver identifies it as

the matching pilot tone and frees the associated signal. Signals without a matching pilot tone remain muted.

Included

LDU30xHHD: Receiver plus hand-held transmitter with dynamic capsule (cardioid), power supply, 2 x AA batteries, audio cable, manual
LDU30xBPH: Receiver plus pocket transmitter and headset (black), power supply, 2 x AA batteries, audio cable, manual
LDU30xBPG: Receiver plus pocket transmitter and guitar cable, power supply, 2 x AA batteries, audio cable, manual
LDU30xBPL: Receiver plus pocket transmitter and Lavalier microphone, power supply, 2 x AA batteries, audio cable, manual
LDU30xBPW: Receiver plus pocket transmitter and clip-on microphone for wind instruments, power supply, 2 x AA batteries, audio cable, manual

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

RECEIVER

1

POWER

On/off switch. Press and hold the button for approximately 1 seconds to turn the device on or off.

2

CHANNEL DISPLAY

Illuminated LC display to show the radio channel.

3

CHANNEL + / -

Push buttons to select the radio channel 01 to 12. To establish a wireless connection between the transmitter and the receiver, the radio frequency

on both machines must match (synchronisation process as described under point 6. ASC).

Advertising