Extron Electronics RGB 150x - Manual (Page 11)

RGB 130xi xi xi xi xi , 134xi xi xi xi xi , 150xi xi xi xi xi Controls and Installation 2-4
RGB 130xi xi xi xi xi rear panel features
Figure 2-4 — RGB 130xi xi xi xi xi rear panel
1 AC power input — standard IEC AC power
connector (100 - 240VAC 50/60 Hz)
2 3-position gain/peak switch — unity*; gain with 50%
peaking; and gain with 100% peaking
3
DIP switches — 4 switches to control sync on green
on output, Digital Display Sync Processing, serration
pulse, and 75-ohm input termination (refer to the
section “Setting the DIP switches”)
4
BNC output — 6 BNC connectors to output RGsB,
RGBS, and RGBHV
5 Stereo audio output — 3.5 mm captive screw audio
connector
* Unity sets the output level equivalent to the input, with no
added peaking.
If the signal cable between the interface and the
display device is shorter than approximately 125
feet, and the level/peak switch is set to a setting
other than Unity, the image may be
overcompensated. If the edges of the image seem to
exceed their boundaries, or if thin lines and sharp
edges look thick and fuzzy, try changing the gain/
peak setting.
SOG DDSP SERR SPARE
100-240 0.5A MAX.
50/60 Hz
OUTPUT
R
H
G
V
B
S
UNITY
50%
100%
GAIN/
PEAK
2 1 3 5 4