Extron Electronics RGB 150x - Manual (Page 6)

RGB 130xi xi xi xi xi , 134xi xi xi xi xi , 150xi xi xi xi xi Introduction
Introduction
About this Manual
This manual documents three universal interfaces: RGB 130xi ,
RGB 134xi, and RGB 150xi. Unless otherwise specified, any
references to “the interface” shall refer to the features or
operation of all three interfaces.
About the Interfaces
The RGB 130xi, 134xi, and 150xi are universal interfaces with a
video bandwidth of 300 MHz and a horizontal frequency range
of 15-150 kHz.
Features
2-color power/signal LED — When the interface is On, the
power/signal LED will light amber. When the
interface is On and a signal is present, the LED will
light green.
Gain/peak control — Increases signal voltages to
compensate for signal degradation caused by long
cable lengths.
Stereo audio — Front panel audio input and a 3.5 mm
captive screw output connector on the rear panel.
Horizontal and vertical shift — The picture can be shifted
horizontally and vertically for the RGB 130xi and
RGB 134xi. The RGB 150xi offers horizontal shifting
only. A min/max LED indicator lights red whenever
the shifting reaches its lower and upper limits.
ADSP™ (Advanced digital sync processing) — Allows
sync processing operations, such as horizontal
centering, to occur without affecting the signal’s sync
timing. This allows horizontal centering to be
applied to signals that are output to digital display
devices, such as LCD projectors, DLP (digital light
amplifier) projectors, and plasma displays.
Under/through desk mounting — The interfaces are
capable of being mounted either under or through a
desk or other suitable surface using the optional
mounting kit.
1-1