Frymaster GC - Manual (Page 23)

4-3
4. Wrap the motor with plastic wrap to prevent water from entering it. Spray degreaser or detergent on
the blower wheel and the blower housing. Allow it to soak for five minutes. Rinse the wheel and hous-
ing with hot tap water, then dry with a clean cloth.
Wrap the motor and
wires with plastic wrap
or a plastic bag.
BLOWER HOUSING BLOWER WHEEL
5. Remove the plastic wrap from the blower motor assembly. Reassemble the blower motor assembly
and blower housing. Reinstall the blower assembly in the cooker and reconnect the wires disconnected
in Step 1.
4. Reinstall the blower shield or shield assembly.
5. Light the cooker in accordance with the procedure described in Chapter 3, Section 3.1.
6. After the burners have been lit for at least 90 seconds, observe the flames through the burner viewing
ports. The air/gas mixture is properly adjusted when the burner manifold pressure is in accordance with
the applicable table on page 4-4 and the burners display a bright orange-red glow. If a blue flame is
observed, or if there are dark spots on a burner face, the air/gas mixture requires adjustment.
On the side of the blower housing opposite the motor is a plate with one or two locking nuts. Loosen
the nut(s) enough to allow the plate to be moved, then adjust the position of the plate to open or close
the air intake opening until a bright orange-red glow is obtained. Carefully hold the plate in position and
tighten the locking nut(s).