FUJITSU ETERNUSmgr P2X0-0202-01EN - Manual (Page 18)

Chapter 2 Setup
>
2.3 Setting Items
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
18
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
2
Edit the STXPOLL_1.INI file.
Vi editor is used here.
# vi /opt/FJSVgrmgr/STXPOLL_1.INI
When setting up multiple target devices, copy an existing setup file to make the setup easier. For
details on how to do this, see
"2.5 Monitoring Multiple Target Devices" (page 34) .
End of procedure
2.2.2 ETERNUSmgr for Windows® Procedure
The following describes how to edit a setup file for ETERNUSmgr for Windows®.
The procedure shown is for changing the settings that were set during installation.
Procedure
1
Confirm the contents of the installation directory using Explorer, etc.
Make sure the following files and folder have been installed in the installation directory:
_stxpoll.ini, STXPOLL.exe, STXPOLL_1.INI, stxpolld.exe, stxsmail.exe, and \www (\www
is a folder).
2
Edit the STXPOLL_1.INI file.
Edit the STXPOLL_1.INI file using a text editor (Notepad, etc.).
End of procedure
2.3 Setting Items
This section explains the setting items (parameters) in the setup files.
2.3.1 Target Device Settings
This section explains the settings that allow ETERNUSmgr to monitor a target device.
■ Target Address
The target address parameter is used to set the IP address or host name assigned to the target
device.
The target port number does not need to be changed (the default number is normally used).
Target address cannot be omitted. ETERNUSmgr will not start if this parameter has not been
set.
Specify SVP IP address if the ETERNUS6000 is using SVP.