FUJITSU 32 - Manual (Page 96)

89
About Adjustment of Offset / Magnification
When clicking the [Offset] button, the following dialog appears.
Note
Depend on some scanner models, once the [Scanner Information] tab appears, the
operation panel is unable to be handled. In this case, close this dialog and turn the power
ON/OFF of the scanner. After the scanner setup, the operation panel is able to be handled.
Using this dialog box, the offset of the leading edge and the magnification for the sub-
scanning direction can be changed.
[Offset Setting]
If the position of the scanned image shifts from the original document, fine adjustment is
possible.
At shipment, the offset has been adjusted to an optimum value within a certain range.
Therefore, adjustment is not generally required.
*The maximum size of changes depends on the device.
Enable eliminating a dark area on the top of the image.
Enable eliminating a dark area on the left side of the image.
These modes can be selected to eliminate the dark area on the leading edge and the left
side appeared when using the flat bed
*These functions may not be displayed for some scanner models.