Motorola APS120 - Manual (Page 20)

WARNING: PBX Extension Length can ONLY be specified during the initial
database setup. If entered incorre c t l y, or if future modifications
a re needed, the database must be deleted and re c re a t e d .
Passwords System Passwor d and Security Code - are four-digit
(Modify Announcements, numbers used to secure the unit and database inform a t i o n ,
Modify Programming) and control access to the unit. These passwords are
needed to record or delete overhead announcements or
names. The system defaults to 6263 for the System
Password and 9832 for the Security Code. Changing these
passwords is recommended. (See Appendix B, System
Passwords for more information.)
Current APS 120/360 Access - user-defined alphanumeric
password to connect the APS Custom PCI program to the
APS Custom unit. The APS Custom 120/360 unit is
shipped from the factory with the APS 120/360 Access
password set to LUCENTAP. If you are connecting to the
APS Custom unit for the first time and the APS Custom unit
is new, the Current APS 120/360 Access field should be set
to LUCENTAP. When creating a new database with the
APS Custom PCI program, the New APS 120/360 Access
field defaults to LUCENTAP. If the APS 120/360 Access
password in the APS Custom unit has already been
changed, the updated password is entered in the Current
APS 120/360 Access field.
New APS 120/360 Access - user-defined alphanumeric
password to change the APS 120/360 Access password
within the APS Custom unit. Normally, the password in the
New APS 120/360 Access field will be identical to the
password in the Current APS 120/360 Access field. When
you need to change the APS 120/360 Access password for
the APS 120/360 unit, the new password must be entered
in the New APS 120/360 Access field. Changing the APS
120/360 Access password in the APS Custom unit is
recommended.
Caller Entry Confirmation - selectable field that controls the
prompting/confirming requested of a caller. The system
defaults to requiring confirmation (e.g., "You entered extension
1234. If this is correct, press one. If you would like to
specify a new extension, press 2.")
Adopt Unit - field for Lucent Technologies factory use only.
When you complete the database information, select OK. A confirmation message
appears on the screen. Select OK. The database name appears at the top right of the
screen. You can now complete the System Configuration, User Information and Remote
Access sections of the database.
!
3 • 4