Next, Lens mounting/removal (cont.) 6, Precautions – Mamiya C330 User Manual

Page 8

Advertising
background image

Mamiya C330S: Page 6

Lens Mounting/Removal (cont.)

6

After changing a lens, set
the parrallax correcting dial

(10)

to the focal length

value of the mounted lens.
For 55mm and 65mm
lenses, set the parallax
correcting dial to 80, then
attach the parallax
correction plate for
55mm/65mm lenses to the
focusing hood. (

Refer to

p.22

). For the 250mm lens,

set the parallax correcting
dial to 180.

Precautions

1 If the film advance crank is not kept
positioned diagonally upward, (the same
angle as the crank housing position), the
cocking lever

(4)

cannot be connected to

the cocking lever on the camera body.

2 For the cocking lever on the 180mm
lens, an auxiliary lever for connection is
provided on the side of the lens barrel.
Since this lever is constantly pushed
upward by a spring, when mounting the
lens, hold the auxiliary lever downward
with a finger tip to prevent obstructing
installation.

3 When the lens lock knob

(11)

is in the

UNLOCK position, the portion to which
the picture taking lens (lower lens) is
attached is protected from the camera
interior by a cover to shield the film from
exposure to light and a red warning signal
is visible on the focusing screen surface.
Should this cover be pushed while
removing the lens, light will strike the
film. Don't push it.

4 After changing a lens, turn the lens lock
knob

(11)

to the LOCK position,

otherwise, the shutter release button
cannot be depressed.

<- Prev

|

Table of Contents

|

Next ->

file:///E|/c330s/page_06.html [22-10-2003 15:26:32]

Advertising
This manual is related to the following products: