Mercedes-Benz 2005 E 320 CDI - Manual (Page 286)

284
Controls in detail
Useful features
Operation of integrated remote control
̈ Switch on the ignition ( ୴ page 33).
̈ Select and press the appropriate inte-
grated signal transmitter button (1,
2 or 3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition ( ୴ page 33).
̈ Simultaneously hold down the signal
transmitter buttons 1 and 3, for ap-
proximately 20 seconds, until the indi-
cator lamp 4 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Press and hold the desired signal trans-
mitter button (1, 2 or 3). Do not re-
lease the button.
̈ The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
i
If you sell your vehicle, erase the codes
of all three channels.