M-S Cash Drawer 7193 - Manual (Page 42)

7193 Owner’s Guide Diagnostics
May 1996
Setting Default Lines per Inch
This function allows you to set the default for lines per inch to either 7.6 or 6.
Caution: The DIP switches are set at the factory to predetermined settings and
should generally not be changed. If you must change the settings, do so carefully
to avoid changing other functions. Run the print test to see what the current
selection is for this function. See “Testing The Printer” On Page 23.
1. Turn the power off.
2. Turn the printer over and note what the current DIP switch settings are.
3. Set the switches to the settings in the table that match the lines per inch
setting you want as the default setting (when the printer is powered up).
Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6 Default LInes per Inch
On Off On On On Off 7.6 (Factory Setting)
On Off On On On On 6.0
4. Turn the power back on to enter the settings into the EEROM.
The On Line light (green) blinks.
5. Turn the power off.
6. Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.