Marathon Computer UNIPRO V3.5 - Manual (Page 94)

Operation
UNIPRO 3.5
Rev. 11.00
December 30,1995
After all characters are as wanted, press the
[ALARM SET] key to place the value in
memory and exit,
or
press [ENTER] to save the value and continue
(forward) editing other parameters,
or
[SHIFT] to save the value and continue (back)
editing other parameters.
NOTE
If an entered number value is not within the acceptable data
range, the maximum/minimum value will flash in the SET
display. Repeat the above procedure until an acceptable value
has been entered.
See “Setup and Configuration” for the Menu table and
parameter definitions. The Alarms are also found there.
VIEWING A PROGRAM WHILE IT IS RUNNING
See “Status Display Page” in Maintenance and
Troubleshooting