JAI VIS-CAM System TS-1327EN - Manual (Page 43)

Installing the Vehicle Imaging Subsystem 31
VIS-CAM System
Figure 29. Connection for LVD to VIS CAM 400.
Table 11 Wiring for LVD to VIS CAM 400.
X7 Pin # Signal Description Connection to
1 24V (Fused 0.5A) Power to laser Laser power input
2 Gnd Power gnd Laser ground
3 Trigger Trigger from laser Trigger out on laser
4 RS485- Transmit to laser Receive input on laser
5 RS485+ Receive from laser Transmit output on laser
6 Gnd Communication gnd Communication gnd on laser
7 nc No connection - -
8 nc No connection -
The cable must be shielded and the shield connected to the metal at the cable entry in the camera
house.
The switch S3 and/or S5 on the J-panel must be in position “positive going” (pushed towards X1/X2)
to enable the laser trigger input on the IO Board.