JVC LYT0633-001A - Manual (Page 63)

EN
63
INDEX Docking Station
1 PC Connector [DIGITAL STILL] ............
੬
pg. 40
2 J Terminal/Edit Connector
[JLIP (Joint Level Interface Protocol)
(EDIT)] ................................................
੬
pg. 49
•Connect to a JLIP-compatible camcorder or
VCR to control it from the computer using the
provided Software.
NOTE:
Make sure that the camcorder is turned on while
connecting the camcorder to a PC using the
Docking Station’s JLIP connector. If the camcorder
is turned off (because the POWER Switch is set to
“OFF” or due to Auto Shut Off* etc.) while the JLIP
programme software is used, it will be impossible
to control the connected devices from the
computer. In such a case, first try turning the
camcorder on again, or unplug the JLIP connection
cable from the Docking Station’s JLIP connector.
Then, initialise or run the software again.
* Auto Shut Off:
If 5 minutes elapse in the Record-Standby mode
or in the Pause mode, the camcorder’s power
shuts off automatically to conserve energy.
•Connect the editing cable when performing
Random Assemble Editing .........
੬
pg. 48 – 53
4
5
6
1
3 0
2
7
8
9
3 External Stereo Microphone Input
Connector [MIC] .................................
੬
pg. 54
4 Stud ....................................................
੬
pg. 38
5 Screw ..................................................
੬
pg. 38
6 Multi Connector
The Docking Station can be connected with this
camcorder through this connector. Never touch it
with your hand or hit it with a hard object; if the
pins are damaged, the connectors will become
unusable due to contact failure.
7 S-Video Output Connector
[S] .................................................
੬
pg. 38, 49
8 Video Output Connector
[VIDEO] ........................................
੬
pg. 38, 49
9 Audio Output Connectors
[AUDIO L/R] .................................
੬
pg. 38, 49
0 Screw Knob .........................................
੬
pg. 38
To attach the camcorder, tighten this clockwise.