Changing the aging time, Spanning tree protocol configuration, Changing the aging time -44 – SMC Networks TigerSwitch 100 User Manual
Page 74: Spanning tree protocol configuration -44
C
ONFIGURING
THE
S
WITCH
2-44
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Usage
The range for the aging time is 17 - 2184 seconds. (The default is 300
seconds.)
Web – Click Address Table, Address Aging. Specify the new aging time,
then click Apply.
CLI – This example sets the aging time to 400 seconds.
Spanning Tree Protocol Configuration
The Spanning Tree Protocol (STP) can be used to detect and disable
network loops, and to provide backup links between switches, bridges or
routers. This allows the switch to interact with other bridging devices (i.e.,
an STP-compliant switch, bridge or router) in your network to ensure that
only one route exists between any two stations on the network, and
provide backup links that automatically take over when a primary link goes
down.
Console(config)#mac-address-table aging-time 400
Console(config)#