Sony BRC-Z700 - Manual (Page 18)

Ov
er
v
ie
w
Location and Function of Parts
18
Location and Function
of Parts
Camera
Front
A Lens
This is a 20-magnification optical zoom lens.
B Tally lamp
Lights in red when a VISCA tally command is
received or the camera is selected by the RM-
BR300 Remote Control Unit (not supplied).
Flashes at intervals of about 0.5 seconds if the
rotating speed of the cooling fan motor is lowered
or the motor has stopped regardless of on/off of the
tally lamp.
C Remote sensor
This is the sensor for the supplied Remote
Commander.
When you use the upper remote sensor, set IMG-
FLIP to ON in the SYSTEM menu (page 36). With
this setting the remote sensor at the rear of the
camera does not function.
D SONY and HD nameplates
Pull them out to turn them over and attach upside
down if necessary.
E POWER lamp
Lights when the camera is connected to an AC
outlet using the supplied AC power adaptor and AC
power cord.
Flashes in green when the camera receives an
operation command from the supplied Remote
Commander.
F STANDBY lamp
Lights when the camera is turned off using the
Remote Commander.
Rear
G VISCA RS-422 connector
Used for VISCA control.
For connection to the VISCA RS-422 connector,
see “Using the VISCA RS-422 Connector Plug” on
page 90.
H 75-ohm termination switch
This switch is used when an external sync signal is
used. Set it to OFF when this camera is in the
middle of a daisy chain connection of multiple
cameras. Set it to ON when the camera is at the end
of a daisy chain connection or when nothing is
connected to the EXT SYNC IN connector on the
camera.
I DATA MIX switch
Set the switch to ON to overlap the menu with the
video signal output from the installed Interface
Board. Set it to OFF not to overlap the menu.
J Remote sensor
This is the sensor for the supplied Remote
Commander.
This remote sensor does not function when IMG-
FLIP is set to ON in the SYSTEM menu.
K IR SELECT switch
Select the camera number when you operate
multiple cameras with the same Remote
Commander.
L
RGB/COMPONENT connector
Supplies the images as analog component (YPbPr
or RGB) signal.
M VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in the daisy chain
connection.
1
5 6
3 2
4
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN VIDEO
IR SELECT
75
1 2 3
OFF ON
DATA MIX OFF ON
IN VISCA RS-232C OUT S VIDEO DC IN 12V
R
qd qf qg qhqj
7 8 9 0 qaqs
qk ql