Stinger JPEG 2000 - Manual (Page 8)

Connections
DVR CONNECTIONS
1. RS-232C Port Connection for control of DVR via PC.
2. Alarm/Relay Inputs/Outputs + PTZ Control.
3. WLAN/Laptop Connection: TCP/IP.
4. Camera Connections.
5. Camera LOOP Outputs.
6. 2 x MONITOR Connections.
NB: BATTERY CONNECTOR
If PIN 1 is connected to a permanent power feed (battery) and PIN 3 to the
ignition power feed this enables the “delay off” feature. This means after
ignition is switched off the recorder will continue to record for approx 30
minutes. If the “delay off” is not required place an insulated jumper wire from
PIN 1 to PIN 3. The DVR will now record only when power is supplied from the
main switch (so long as the permanent power feed is behind the main switch).
Battery connector – Amphenol C16-1 3W+ PE plug PG 9
Pin 1 12 VDC or 24VDC (dependant on version ordered)
Pin 2 GND
Pin 3 12 VDC or 24VDC ignition feed (delay off controller)
12VDC camera / TFT connector – Amphenol C16-1 3W + PE PG 9
+12VDC
-12VDC (0V – isolated from Vehicle ground)