Kawasaki STX-15F - Manual (Page 111)

FUEL SYSTEM (DFI) 3-57
Oil Temperature Sensor (Service Code/Character-73/OILC or 73/OILt)
Service Code/Character
JT1500-A1: 73/OILC
JT1500-A2 ∼ : 73/OILt
Oil Temperature Sensor Removal/Installation
CAUTION
Never drop the sensor, especially on a hard surface.
Such a shock to the sensor can damage it.
•
Remove:
Engine (see Engine Removal/Installation chapter)
Oil Temperature Sensor [A]
•
Fill the hollow of the oil pan [A] with the specified silicone
grease [B] as shown, before installing the oil temperature
sensor [C].
[D] 5 mm (0.2 in.)
Silicone Grease-Kawasaki Bond: 92137-1002
•
Tighten:
Torque - Oil Temperature Sensor: 15 N·m (1.5 kgf·m, 11
ft·lb)
Output Voltage Inspection
NOTE
○
Be sure the battery is fully charged.
•
Remove the ECU (see this chapter). Do not disconnect
the connector.
•
Connect a digital voltmeter [A] to the ECU connector [B],
with the needle adapter set.
Special Tool - Needle Adapter Set: 57001-1457
Water Temperature Sensor Output Voltage
Connections to ECU
Meter (+) → Y lead (terminal 37)
Meter (–) → BK/W lead (terminal 8)
•
Turn the ignition switch ON and push the lanyard key un-
der the stop button.
•
Pushing the start button, run the engine 5 ∼ 6 seconds at
idling to measure the sensor output voltage.
○
Wait 15 seconds before using the starter again.
Output Voltage at ECU
Standard: about 3 ∼ 4 V at 20°C (68°F)
NOTE
○
The output voltage changes according to the oil temper-
ature in the engine.