Installation, Hopper extension set-up – Lopi Yankee Bay Pellet Insert User Manual

Page 8

Advertising
background image

8

Installation

Travis Industries

4 0 5 0 5 0 9

1 0 0 - 0 1 1 4 5

Hopper Extension Set-up

This pellet heater has a variable-height hopper. This allows the hopper to be lowered for smaller
fireplaces. Follow the instructions below to set the correct hopper extension position.

Determine the correct hopper extension position following the directions below.

The unit will extend 14” into the fireplace. For

setting the hopper, the maximum fireplace

opening measurements have to be taken at 14”

into the fireplace.

Hopper Extension Position

A (highest position)

25-3/4”

B (next highest)

24-1/2”

C etc...

23-3/8”

D etc...

22-1/4”

E etc...

21-1/8”

F (lowest position)

20”

Remove the hopper top following the directions below.

Remove the hopper top by removing

the screws holding it in place.

1/4" Nutdriver

Hopper Top

NOTE: with the hopper top removed,

the hopper walls may be removed.

Remove the hopper walls.

Advertising