Pioneer Multi Projection System RM-V1000NU - Manual (Page 110)

109
APPENDIX (MVP manual)
VIDEO OUTPUT MODE OF MVP
¶ The video output formats set by the mode switches are as shown in the following table.
(At shipment, the mode switch value is set to “8”.)
¶ Bus format : NTSC .............. NTSC digital signal transmission method.
¶ Output format
: VBS (VIDEO signal), Can be switched between Y/C and RGB.
However, VBS and Y/C can only be used for the standard speeds.
¶ Sync signal frequency : Standard speed ..... Horizontal 15.734 kHz, vertical 59.94 Hz interlace
: Double speed ......... Horizontal speed 31.469 kHz, vertical 59.94 Hz non-interlace
¶ Trunk piece mitigation mode : It is the function that mitigates the trunk piece phenomenon by multiple visions
unique scanning line structure. There is a difference in an effect by the magnifi-
cation ratio and it is more effective as smaller of the magnification ratio. Yet, it
does not work in vertical magnification ratio X1.
(Note)
MPJ inputs can only be set to the standard speed. Double-speed playback cannot be performed.
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
NTSC
NTSC
VBS, Y/C
RGB
VBS, Y/C
RGB
Standard speed
Double speed
Standard speed
Double speed
OFF
ON
Reserved
Reserved
Mode switch No. Bus format Output format Sync signal frequency Trunk piece mitigation mode