NEC 5224 - Manual (Page 31)

25
3. Do one or all of the following:
• To call the message sender, press #.
• To erase the message, press *.
To respond to a message waiting condition on your 5224 IP Phone:
1. Press ( MESSAGE ).
2. If a password is required, dial your password (and press the Enter softkey if available).
3. Press the Yes softkey, and do one or all of the following:
• To display the time the message was sent, press the More softkey.
• To display the number of the caller, press the More softkey twice.
• To call the message sender, press the Call softkey.
• To delete the message, press the Erase softkey.
• To view the next message, press
( MESSAGE ).
On a 5224 IP Phone only, you can check for messages from a remote station:
1. Press ( SUPERKEY ).
2. Press the No softkey until "Remote Msging?" appears.
3. Press the Yes softkey.
4. Dial your extension number.
5. Press the Enter softkey.
6. If a password is required, enter your password and press the Enter softkey.
7. Press the Yes softkey.
On a 5224 IP Phone only, you can set, change, or clear a password (up to 7 digits, not including
0):
1. Press ( SUPERKEY ).
2. Press the No softkey until "Set Password?" appears.
3. Press the Yes softkey.
4. Do one of the following: