Neuton CE 6.2 - Manual (Page 51)

NEUTON CE 6.2 Battery-Powered Mower - Safety & Operating Instructions 47
Starting the Trimmer
The Battery in the NEUTON Mower powers the Trimmer, making the cutting cord spin. Make sure the
Battery has a full charge before you begin.
•
STARTING, STOPPING, AND RESTARTING AN ELECTRIC MOTOR REPEATEDLY WITHIN A FEW SECONDS
CAN GENERATE A GREAT DEAL OF HEAT AND DAMAGE THE MOTOR. TO PROTECT THE LIFE OF YOUR
NEUTON TRIMMER, ALWAYS WAIT AT LEAST FIVE (5) SECONDS AFTER STOPPING BEFORE RESTARTING
THE TRIMMER.
• THE CUTTING CORD ALWAYS TURNS WHEN THE MOTOR IS RUNNING; THERE IS NO CLUTCH TO ALLOW
THE CORD TO STOP ROTATING WHILE THE MOTOR IS RUNNING.
1. Set the Power/Mode Switch to Auxiliary (Figure 18 on page 19).
NOTE: The Cutting Blade on the Mower does not turn when the Power/Mode Switch is in the Auxiliary
position.
2. Insert the Safety Key into the Key Slot. The green Status Indicator Light should come ON.
3. Slide the orange Start Knob to the left and then squeeze and hold the orange Control Bar
(Figures 22 & 23 on page 25). The Trimmer motor will now start and run for as long as you are
squeezing the Control Bar.
Stopping the Trimmer
Simply release the Control Bar to Stop the Trimmer.
THE TRIMMER WILL CONTINUE TO ROTATE FOR A COUPLE OF SECONDS AFTER YOU RELEASE THE CONTROL
BAR. WAIT FOR THE MOTOR TO STOP BEFORE MOVING THE MOWER. REMEMBER TO WAIT AT LEAST FIVE
(5) SECONDS AFTER STOPPING BEFORE YOU RESTART THE TRIMMER MOTOR.
When you are finished trimming or edging, remember to remove the Safety Key.