Nvidia N61S User Manual

Page 24

Advertising
background image

- 2 -

nVIDIA N61P/N61S/N61V User's /Manual

Swap Floppy Drive

If you have 2 floppy drives, you can change A to B, or change B to A.

Boot Up Floppy Seek

During POST, BIOS will determine if the floppy disk drive installed if choose [Enable].

Boot Up NumLock Status

This item defines if the keyboard Num Lock key is active when your system is started.

Gate A20 Option

[

Normal]: The A20 signal is controlled by keyboard controller or chipset hardware.

[Fast]: (default) The A20 signal is controlled by port 92 or chipset specific method.

Typematic Rate Setting

Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the

typematic rate and typematic delay can be selected.

Typematic Rate (Chars/Sec)

Set the number of times a second to repeat a keystroke when you hold the key down.

The settings are: 6, 8, 10, 12, 15, 20, 24, and 30.

Typematic Delay (Msec)

Set the delay time after the key is held down before is begins to repeat the keystroke.

The settings are 250, 500, 750, and 1000.

Security Option

This item determines when the system will prompt for password - every time the system

boots or only when enters the BIOS setup.

[Setup]: The password is required only when accessing the BIOS Setup.

[System]: The password is required each time the computer boots up.

APIC MODE

This field is used to enable or disable the APIC (Advanced Programmable Interrupt

Controller). Due to compliance with PC2004 design guide, the system is able to run in

APIC mode. Enabling APIC mode will expand available IRQ resources for the system.

MPS Version Control For OS

This item specifies which version of MPS (Multi-Processor Specification) this mainboard

will use. Leave this item at its default setting.

OS Select For DRAM > 64MB

Allow OS2 to be used with >64MB or DRAM. Settings are Non-OS/2 (default) and OS2.

Set to OS/2 if using more than 64MB and running OS/2.

Full Screen LOGO Show

This item determines to show the full screen logo when booting.

Small Logo(EPA) Show

EPA Logo is the sign at the top of the screen when POST. If you don't want to show this

logo, please set "Disabled".

Advertising
This manual is related to the following products: