Panel mounting, Figure 1-4. mounting the usb-621x on a panel, Panel mounting -5 – National Instruments Data Acquisition Device NI USB-621x User Manual
Page 22
Chapter 1
Getting Started
© National Instruments Corporation
1-5
Panel Mounting
To mount the USB-621x to a board or panel, complete the following steps
while referring to Figure 1-4.
Figure 1-4. Mounting the USB-621x on a Panel
Note
Do not apply the rubber feet to the USB-621x when panel mounting the device.
Note
Apply strain relief, as described in the
section, before panel
mounting the USB-621x.
1.
Download and print the panel mounting template PDF attached in the
KnowledgeBase document, USB-621x Panel Mounting Template.
Go to
ni.com/info
and enter the info code
ex3x98
to locate the
KnowledgeBase.
2.
Using the template, mark the bottom point and top point on the panel.
(USB-621x Screw Terminal Devices)
The points will be 171.45 mm
(6.75 in.) from each other.
(USB-621x Mass Termination Devices)
The points will be 182.56 mm
(7.188 in.) from each other.