Radio Shack 1500 - Manual (Page 9)

9
5. Align the phone stand’s keyhole
slots with the studs on the wall
plate and slide the phone down
until it snaps into place.
Direct Wall Mounting
You can mount the phone directly on
the wall using two screws (not sup-
plied).
Note: Make sure the screw’s heads fit
the phone stand’s keyhole slots.
1. Drill two holes, one above the
other, 3 1 /
4
inches apart, then
thread the screws into the holes
until the heads extend about
1 /
8
inch from the wall.
2. Plug one end of the supplied long
modular phone cord into the TEL.
LINE jack on the phone.
3. Route the cord through the groove
on the back of the phone.
4. Insert the tabs on the narrow end
of the stand into the matching
slots near the top of the phone,
making sure the cord is routed
through the opening in the stand.
Then snap the stand into place by
pressing in the two tabs toward
the bottom of the phone.
43-976.fm Page 9 Monday, August 16, 1999 4:38 PM