Radio Shack 63-1416 - Manual

© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
OWNER’S MANUAL —
Please read before using this equipment.
www.radioshack.com ™
63-1416
Thank you for purchasing a RadioShack 1.8 Inch Big Digit Atomic Clock. Your clock tells Atomic
time, so it sets itself automatically when it receives the WWVB signal transmitted by NIST in
Fort Collins, Colorado. It has a bold, easy to read display with a Hi-Lo dimmer that allows you to
adjust the brightness for greater readability. With four time zones selection, you can set the
clock to the correct time by just sliding a switch!
%100'%6+0)"219'4
To power the alarm clock, plug the clock's
power cord and transformer into any
standard AC outlet.
0ý&& 0ý&& 0ý&& 0ý&& appears and
H H H H
flashes. The clock searches for the WWVB
signal.
+ 056#..+0) " 6*' "$ #%-72 "
$ #66'4; "
You can install a backup battery so you do
not lose your clock settings if there is a power
failure. The display turns off during a power
failure, but, for 24 hours, the clock continues
to run and the alarms sound at the preset
alarm times.
Your clock requires one 9V battery (not
supplied) for backup power. For the best
performance and longest life, we recommend
RadioShack alkaline batteries.
± ± ± ± . . . . RRRRý
1. Slide the battery compartment cover in
the direction of the arrow to remove it.
2. Place the battery in the compartment as
indicated by the polarity symbols
(+ and –) marked inside.
3. Replace the cover.
When LO BAT lights, the backup battery is
low. Replace the battery.
5'66+0)"6*'"6+/'"
<10'"
Slide Time Zone , located on the back of the
clock to select the desired time zone.
If the clock does not receive the signal in the
first 20 minutes, set it manually. The clock
adjusts itself automatically to the exact time
within 48 hours.
& #;.+)*6 "5 #8+0)5 "6 +/'
Set DST , located on the back of the clock, to
ON unless the clock is used in an area
without Daylight Savings Time (DST). Set
DST to OFF if the clock is used in an area
without DST. ± ± ± ±
5 '66+0) " 6*' "6 +/'
1. To set the hour, press and hold TIME SET
and then press (or press and hold) Hour/
WAVE until the desired hour appears. ± ± ± ±
2. To set the minute, press and hold TIME
SET and repeatedly press (or press and
Four Time Zones —
slide the time zone
switch to select
Pacific Standard
Times (PST),
Mountain Standard
Time (MST), Central
Standard Time (CST),
or Eastern Standard
Time (EST).
Daylight
Saving Time
(DST) —
adjusts to
Daylight
Saving Time
automatically
when it
receives the
WWVB signal.
Backup Battery —
powers the clock
during a power failure
Daily Dual Alarm —
two separate alarms
with different sounds.
"
R
"9#40+0)"
R
"
Dispose of batteries promptly and properly. Do
not burn or bury them.
.
"%#76+10"
.
• Use only a fresh battery of the required size
and recommended type.
• If you do not plan to use the clock with
batteries for a week or more, remove the
batteries. Batteries can leak chemicals that
destroy electronic parts.
± ± ± ± "016'" ± ± ± ± "
Installing the Backup Battery
To prevent unnecessary drain on the battery,
make sure you connect the alarm to an AC
power outlet before you install the battery.
Setting the Time Zone
Parts of Arizona and Indiana do not participate in
Daylight Savings Time.
Setting the Time
• The defaulted clock setting is 12:00 a.m.
• PM lights if it is a p.m. hour.
# "+/2146#06" #
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for
pertinent information.
RRRRý
— Warning
#
— Important ± ± ± ± — Note
. . . .
— Caution
° ° ° °
— Hint
30:"+PEJ"$KI"&KIKV"#VQOKE"%NQEM
WARNING: To reduce the risk of fire or
shock hazard, do not expose this product to rain
or moisture.
CAUTION
RISK OF ELECTRIC
SHOCK. DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
This symbol is intended to alert
you to the presence of
uninsulated dangerous voltage
within the product’s enclosure that
might be of sufficient magnitude
to constitute a risk of electric
shock. Do not open the product’s
case.
This symbol is intended to inform
you that important operating and
maintenance instructions are
included in the literature
accompanying this product.
!
!