Texas Instruments TVP5154EVM - Manual (Page 11)

www.ti.com
WinVCC Quick Start
Figure 4. WinVCC – I 2 C Configuration Screen
3. Ensure that all other boxes are selected as “Not Used” and that all program options buttons are set to
ENABLE. Click OK.
4. If there are no I 2 C communication issues, the Real-Time Polling dialog window displays next as shown
in Figure 5 . If there are I 2 C issues, an I 2 C Test Report box displays. Completely exit out of WinVCC,
double-check the parallel port cable connections, I 2 C address settings, cycle power on the
TVP5154EVM, and re-run WinVCC.
5. When using the TVP5154 EVM with a composite output from the 7311 encoder, it is required to disable
auto-switch polling in the Real-Time Polling dialog box by clicking on the ENABLED button. Click OK
and then the Main Control Window is seen, as shown in
Figure 7 .
SLEU069A – February 2006 – Revised July 2006 TVP5154EVM User's Guide 11
Submit Documentation Feedback